Unofficial Mackie User Forums > DL1608/DL806/DL32R/ProDX Mixers

docked iPad loses sync

<< < (37/44) > >>

WK154:

--- Quote from: RoadRanger on September 18, 2014, 08:08:09 PM ---Maybe a series resistor on the power line would work just as well?

--- End quote ---
Already there as a 166 ohm on ground return, unfortunately it affects all signals that reference that ground. ::)
Don't ask!
 

RoadRanger:

--- Quote from: WK154 on September 18, 2014, 09:31:26 PM ---
--- Quote from: RoadRanger on September 18, 2014, 08:08:09 PM ---Maybe a series resistor on the power line would work just as well?

--- End quote ---
Already there as a 166 ohm on ground return, unfortunately it affects all signals that reference that ground. ::)
Don't ask!

--- End quote ---
So, when it is charging at 2 amps there's a 332 volt drop across it ;) ? I'm pretty sure that resistor isn't in the charging ground :) .

WK154:

--- Quote from: RoadRanger on September 18, 2014, 10:42:19 PM ---
--- Quote from: WK154 on September 18, 2014, 09:31:26 PM ---
--- Quote from: RoadRanger on September 18, 2014, 08:08:09 PM ---Maybe a series resistor on the power line would work just as well?

--- End quote ---
Already there as a 166 ohm on ground return, unfortunately it affects all signals that reference that ground. ::)
Don't ask!

--- End quote ---
So, when it is charging at 2 amps there's a 332 volt drop across it ;) ? I'm pretty sure that resistor isn't in the charging ground :) .

--- End quote ---
Where do you get 2 amps from?

RoadRanger:
Apple's iPad charger is rated at 2.1 amps.

WK154:

--- Quote from: RoadRanger on September 19, 2014, 12:46:41 AM ---Apple's iPad charger is rated at 2.1 amps.

--- End quote ---
That's Apple but Mackie's puny little 5V supply probably only puts that out for everything 5V in the DL. I've yet to see a spec on the charging current for the DL/iPad. Something I was planning to measure if I get to the cable experiment.
Corrected see report below.

Navigation

[0] Message Index

[#] Next page

[*] Previous page