Cacophony Forums
Unofficial Mackie User Forums => DL1608/DL806/DL32R/ProDX Mixers => Topic started by: 1kidc on August 25, 2019, 09:30:17 PM
-
Running 4.5 on an original dl1608..
I've been using this mixer w/ my wedding band since the 1608 came out. New vocalists over the years have made a hash out of their aux iem mixes - to the point that I'm not sure WHAT they have done lol. I know, give them some freedom and god knows what havoc they will cause...
Is there a way to bring an individual aux back to the original factory settings while keeping other aux mixes intact? My long time rhythm section players are going to scream bloody murder if I mess with their aux mixes that they've been tweaking for years to get right.
Sorry if this has been covered before. I look forward to your guidance!
-
Hardly rocket science. Turn all channels down to zero and start again. Should take about two minutes.
-
Yep = one of them was set post fader etc. just wasn't sure what else they might have mucked up along the way... And yeah, I'm going to set their permissions while i'm at it...