Cacophony Forums

Curious how just tonight I was sharing my experience and fondness for the unit and MasterFader in particular to an audio tech inexperienced with the combo.
And it was just a bit over ten years ago,of the DL1608 product announcement.

New to digital mixers and finding my way with a dl16s.

Tonight at rehearsal, channel 1 which had a shure radio mic connected stopped responding. If I tapped the mic l could here that but the vocal was not there. Finally I reset the amp and it started to work again.
I think this happened after some feedback when trying to set the gain and trim, Is there some sort of protection device on each channel that cuts out, if so what is the procedure for resetting it?
If not what else could have caused this?

Thanks
David

Hello,

Long time gigging musician here and new to using a digital mixer. I recently purchased a DL16S and am very happy with it. Here is my issue I can not figure out: When I run my Subwoofer from Aux it works great. When I try running out to my subwoofer from my mains it will not get any significant volume however my mains speakers work fine. Any idea what would be causing the lack of signal to my subwoofer when hooked up to my mains? I can not run the sub from the aux as I have a 6 piece band all using IEM.

Any suggestions?

Hi Art,

    The Corcom C-series is close, but shorter in height. 
The Yunpen unit in the mixer is rated at 6A.

    Mackie sent me to a third-part repair service that will only sell the part after
I ship the mixer to them and pay a bench service fee.

    On another forum a poster found the part at German distributor Conrad:
 https://www.conrad.ch/de/p/yunpen-yr06a3-entstoerfilter-mit-schalter-mit-kaltgeraetebuchse-250-v-ac-6-a-0-7-mh-l-x-b-x-h-41-1-x-31-6-x-56-mm-1-st-1326741.html?utm_source=tradedoubler-de&utm_medium=affiliation&utm_campaign=general&utm_content=deeplink_cpo
He is going to get a couple for me. 
Apparently the part is being discontinued, so if anybody wants a spare...

    Another option I found is this:
https://www.digikey.com/en/products/detail/schaffner-emc-inc./FN285-2-06/1997121?utm_adgroup=General&utm_source=bing&utm_medium=cpc&utm_campaign=Smart%20Shopping_Product_Zombie%20SKUs&utm_term=&utm_content=General&utm_id=bi_cmp-408786779_adg-1295224999087968_ad-80951627048660_pla-4584551177443323_dev-c_ext-_prd-1997121&msclkid=df71c88155a81e077d4daac8f36c31da
It's too big, but would fit an enlarged hole.  It adds a fuse.

Thanks and good health,  Weogo

Hi,

    Good suggestion, but the DL16S has a different IEC inlet, with no fuse.
It is a combo  IEC inlet, switch, and EMI filter.
there's no access to the inards from the front, back, top/bottom or sides.

 https://www.avshop.ca/images/mackie/DL16S_Side.jpg

Thanks and good health,  Weogo