Cacophony Forums
Unofficial Mackie User Forums => DL1608/DL806/DL32R/ProDX Mixers => Topic started by: SGravy on June 23, 2017, 09:14:47 AM
-
I know you can pan linked Aux's but is there a way to pan linked channels?
I've scanned the manual but can't see anything. Any thoughts appreciated.
-
Mayby u can use the pan button?!?!?!
-
What I'm after doing is to have one channel hard panned L and the other hard panned R. Obviously I can do that if I un-link the channels but that's more fingers!
-
Disclaimer - I don't have my DL to hand right now to confirm this but...
When you link 2 channels one is automatically hard L, the other hard R. In this configuration the (mono) pan control becomes a (stereo) balance control, as one used to see on stereo HiFi amps.
You have, of course, piqued my doubt now so I'll have to check this out now.
-
Thank. If that's the case great - but it was not sounding as separated as I was expecting. I wondered if I'm still getting some of the L appearing in the R channel! I'll try to set it up tonight and unlink them and see if it makes a difference.
-
Thank. If that's the case great - but it was not sounding as separated as I was expecting. I wondered if I'm still getting some of the L appearing in the R channel! I'll try to set it up tonight and unlink them and see if it makes a difference.
I use an iPad on two linked inputs and I'm 99% sure it's automatically hard panned l/r when linked because my cable was wonky once and the left side of the room couldn't hear anything....