Unofficial Mackie User Forums > DL1608/DL806/DL32R/ProDX Mixers

Newb with a few questions

<< < (2/2)

RoadRanger:
Are you sure you put the 100 ohm resistor from pin 2 to pin 3 ? I probably just plugged in one of my switched mics but those are a short when "off". In any case I've not had any issue in normal operation.

WK154:
Yup had these test plugs for decades 1% metal film. I don't have a problem with the DL just answering the OP on his "boatload" problem. Yorgaki1 there is a number for the "boatload" along with all other conditions that would help to answer your question!

RoadRanger:
Just a comment on the trim controls:
They have a huge amount of gain full up and have a very controllable "curve" with plenty of attenuation for "hot" signals. One of the bands I work with has an Axe FX guitar amp simulator that the guitarist tells me has required the use of an in-line attenuator on every mixer he's used it with except the DL1608. I do carry a 10 dB attenuator I've had to use on other mixers for "hot" outputs from keyboard amps and such - even when those mixers had a "pad" button. The DL1608 has no need of a pad button :) .

Yorgaki1:
Thanks for your your responses fellas.

WK154:
Well what if anything was the problem ? I's not a one way street.

Navigation

[0] Message Index

[*] Previous page