« previous next »
Pages: [1]

Author Topic: Wireless connecting  (Read 3573 times)

ggraue

  • Initiate
  • *
  • Location:
  • Posts: 2
Wireless connecting
« on: March 17, 2013, 07:29:14 PM »
Another struggle I have had (I am a new owner) is getting the iPad to connect to the wireless. When I boot up the iPad, it sees the SSID of the wireless for my mixer and connects to it.  I slide the iPad into the mixer, do  my setups, and then slide the iPad out. It does not seem to be able to find the mixer and goes offline.

I have tried turning off the router, mixer, iPad and then powering up the router, then the mixer and finally the iPad. I have to do this over and over until the iPad connects to the mixer over the wireless.

This is very frustrating and wastes a lot of time before the show.  What am I doing wrong?
Logged

RoadRanger

  • SysGod
  • Counselor
  • Master
  • *****
  • Location: NE CT USA
  • Posts: 1776
  • "Wherever you go, There you are"
    • Cacophony Forums
Re: Wireless connecting
« Reply #1 on: March 17, 2013, 07:46:42 PM »
You have to turn on the router before the mixer and allow it to fully boot before powering up the mixer. My router takes a full 1.25 minutes to boot :eek:. When the mixer is powered up it seems to only try once to find an IP and if that fails never tries again :facepalm:. I hope that they fix that to try every few seconds or so if an Ethernet connection is detected :) .
Logged
Pages: [1]
« previous next »