I knew it couldn't be this easy! ... Got my DL32R yesterday. So this morning I decide to test it. I connect it to the router that I have been using with my DL1608, turn everything on and so far so good. The iPad (Which was used with the DL1608 sees the network and when opening up Master Fader, it sees the DL32R .. So far so good. When I connected to the DL32R it immediately told me that a firmware update must be done to the DL32R. No problem, I let it do it's thing. After a minute, it completed successfully. -- Here is where the fun begins. The DL32R rebooted after the firmware update and came back up with no issues. My iPad sees the DL32R. When I choose to connect to it, however, I got a message "This iPad is running a Show intended for use on a DL1608. In order to connect to the DL32R, you will need to switch to its Show, which can take up to 2 seconds per Snapshot and 30 seconds per image. Proceed? (Yes, switch to show -- or -- No, Go Offline)" ....... I select Yes, switch to show. it then comes up with the "Synchronizing current state" window and then quits. After restarting, the same thing keeps happening. -- I uninstalled Master Fader and reinstalled it. Same thing is happening. Cannot run Master Fader at all. The App keeps quitting right after syncing current state. -- Mind you, this scares the S^&T out of me. -- If this ever happens on a gig ...... I have had ZERO issues with either of my DL1608's (2 of them). Now This. Anyone else go from a DL1608 to a DL32R? -- I hate being an early adopter, but I can't help myself LOL!