Panning Linked Channels

[SGravy]

I know you can pan linked Aux's but is there a way to pan linked channels?

I've scanned the manual but can't see anything. Any thoughts appreciated.

[Ampli]

Mayby u can use the pan button?!?!?!

[SGravy]

What I'm after doing is to have one channel hard panned L and the other hard panned R. Obviously I can do that if I un-link the channels but that's more fingers!

[shufflebeat]

Disclaimer - I don't have my DL to hand right now to confirm this but...

When you link 2 channels one is automatically hard L, the other hard R. In this configuration the (mono) pan control becomes a (stereo) balance control, as one used to see on stereo HiFi amps.

You have, of course, piqued my doubt now so I'll have to check this out now.

[SGravy]

Thank. If that's the case great - but it was not sounding as separated as I was expecting. I wondered if I'm still getting some of the L appearing in the R channel! I'll try to set it up tonight and unlink them and see if it makes a difference. 

[JohnMHoyt]

Thank. If that's the case great - but it was not sounding as separated as I was expecting. I wondered if I'm still getting some of the L appearing in the R channel! I'll try to set it up tonight and unlink them and see if it makes a difference.

I use an iPad on two linked inputs and I'm 99% sure it's automatically hard panned l/r when linked because my cable was wonky once and the left side of the room couldn't hear anything....